a wireless base station antenna, the lower the power output of the device

power level, the actual SAR level of the device while operating can be well below the maximum reported value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closeryou are to

a wireless base station antenna, the lower the power output of the device.

For more information about SAR, visit:

•https://www.fcc.gov./general/ radio-frequency-safety-0

•www.fcc.gov/encyclopedia/specific- absorption-rate-sar-cellular-telephones

Before a new model device is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the SAR limit established by the FCC. Tests for each model are performed in positions and locations (for example, at the ear, worn on the body, orworn on the wrist) as required by the FCC. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.

For typical operation, this device has been tested and meets FCC SAR guidelines. The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.

SAR values for body-worn devices are measured when used with an accessory that contains no metal and that positions the device a minimum of x.x cm from the body.

19