ID SET, ID SET, ID SET, CAUTION

2.Check the standby status of the Wireless Receiver Module after plugging it into an electrical outlet.

•• The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please refer to the SWA-8500S user manual.

3.Press and hold the Up button on the remote control for at least 5 seconds.

•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.

•• The Soundbar will automatically power on when ID SET is complete.

SOUND

MODE

CAUTION

•• If your Soundbar was playing music when it connects to the SWA-8500S, you may hear some stuttering from the woofer as the connection finalizes.

4.Check if the LINK LED is solid blue (connection complete)

5.If SWA-8500S is not connected, repeat the procedure from Step 2. ENG - 9