Sound Control



BASS



VOL

•• Volume restriction function

Because it may damage hearing when the power is turned on at high volumes, it adjusts the volume to 20 when the set volume is higher than 20.

––The default value for Volume restriction is off. The set volume is maintained even when the power is turned off.

––To change the setting, press and hold the Down button on the remote control for 5 seconds. With the volume restriction off, “V FREE” appears on the front display and with the function on, “V LOCK” appears.

You can select from TREBLE, AUDIO SYNC, REAR LEVEL, or REAR SPEAKER ON/OFF.

•• To adjust the TREBLE volume, select Sound Control TREBLE, and then use the Up/Down buttons to adjust the volume within the -6 to +6 range.

•• Press and hold the (Sound Control) button for about 5 seconds to adjust the sound for each frequency band. 150Hz, 300Hz, 600Hz, 1.2KHz, 2.5KHz, 5KHz, and 10KHz are selectable (Left/Right) and each can be adjusted to a setting between -6 ~ +6 (Up/ Down).

•• If the video and audio between the TV and your Soundbar are not synchronized, select AUDIO SYNC in Sound Settings, and then set audio delay between 0~300 milliseconds by using the Up/Down buttons. (Except “USB” mode)

•• If surround speakers (not supplied) are connected, select REAR LEVEL and use the Up/ Down buttons to adjust the volume within the -6 to +6 range.

The REAR SPEAKER function can be turned ON/OFF by using the Up/Down buttons.

•• AUDIO SYNC is only supported in some functions.

Push the button up or down to adjust the bass volume within the -6 to +6 range. To set the bass volume level to 0, press the button.

Push the button up or down to adjust the volume.

•• Mute

Press the VOL button to mute the sound. Press it again to unmute the sound.