If the device fails to connect
•• If the previously connected Soundbar listing (e.g. “[AV] Samsung Soundbar Mxxx
•• In “BT” mode, press and hold the 
(Source) button for more than 5 seconds on the right side panel of the Soundbar or on the remote control to switch to “BT PAIRING” mode.
Then, select “[AV] Samsung Soundbar Mxxx
What are the BT READY and BT PAIRING statuses?
•• BT READY : In this mode, you can search for previously connected TVs or connect to the Soundbar from a previously connected mobile device.
•• BT PAIRING : In this mode, you can connect to a new device (while in “BT” mode, press and hold the
(Source) button for more than 5 seconds on the right side of the Soundbar or on the remote control.)
NOTES
•• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.
•• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the Soundbar and the Bluetooth device exceeds 32.8 ft.
•• The Soundbar automatically turns off after 5 minutes in the Ready state.
•• The Soundbar may not perform Bluetooth search or connection correctly under the following circumstances:
•• Electronic devices may cause radio interference. Devices that generate electromagnetic waves must be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.
Disconnecting the Soundbar from the TV
Press the 
(Source) button on the right side panel or on the remote control and switch to any mode but “BT”.
•• Disconnecting takes time because the TV must receive a response from the Soundbar. (The time required may differ, depending on the TV model.)
•• To cancel automatic Bluetooth connection between the Soundbar and TV, press the
p(Play/Pause) button on the remote control for 5 seconds in “BT READY” status. (Toggle On → Off)
ENG - 12
