Manually connecting the Subwoofer if automatic connection fails
Before performing the manual connection procedure below:
•• Check whether the power cables for the Soundbar and subwoofer are connected properly.
•• Make sure that the Soundbar is turned on.
1.Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
•• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
5 Sec
Rear of Subwoofer
2.Turn off the Soundbar.
3.Press and hold the VOL button on the remote control for at least 5 seconds with the Soundbar turned off (OFF).
•• The ID SET message appears on the display of the Soundbar for 1.3 seconds, and then disappear.
| B | PO5 Sec |
| SOUND | |
Surround | MODE | |
|
| |
VOL
WOOFER SOUNDBAR
ID SET
4.While the subwoofer’s indicator is blinking blue, press the 
(Power) button on your remote control or on the right side of the main unit to turn on the main unit.
5.The connection is complete if the indicator on the rear of the subwoofer stops blinking and glows continuously.
•• If the connection process fails, the blue indicator will flash continuously. Go back to Step 1 and start again.
ENG - 6
