1. Place the Wall Mount Guide against the wall | 3. Push a pen tip or sharpened pencil tip |
|
| |||||
surface. |
| through the center of the | ||||||
•• The Wall Mount Guide must be level. |
| each end of the Guide to mark the holes for | ||||||
•• If your TV is mounted on the wall, install |
| the supporting screws, and then remove the | ||||||
the Soundbar at least 2 inches (5 cm) |
| Wall Mount Guide. |
|
|
|
| ||
below the TV. |
|
|
|
|
|
|
|
|
| A | B | CENTER LINE | B | A |
| ||
|
|
|
|
|
|
|
| |
2 inches or more
2.Align the Paper Template’s Center Line with the center of your TV (if you are mounting the Soundbar below your TV), and then fix the Wall Mount Guide to the wall using tape.
•• If you are not mounting below a TV, place the Center Line in the center of the installation area.
A | B | CENTER LINE | B | A | |
|
|
|
|
|
Center Line
B
4.Using an appropriately sized drill bit, drill a hole in the wall at each marking.
•• If the markings do not correspond to the positions of studs, make sure you insert appropriate anchors or mollies into the holes before you insert the support screws. If you use anchors or mollies, make sure the holes you drill are large enough for the anchors or mollies you use.
5.Push a screw (not supplied) through each
ENG - 19
