2. Check the standby status after plugging into an electrical outlet

2. Check the standby status after plugging into an electrical outlet

The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue).

POWER

3. Configure “ID SET” using the Soundbar’s remote control

Press and hold the Up button on the remote control for at least 5 seconds.

•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.

•• The Soundbar will automatically power on when ID SET is complete.

SOUND

MODE

CAUTION

•• If your Soundbar was playing music when it connects to the SWA-9100, you may hear some stuttering from the woofer as the connection finalizes.

ENG - 21