Center Line, A-TYPE, Wall Mount Guide, Holder-Screw

2.Align the Wall Mount Guide’s Center Line with the center of your TV (if you are mounting the Soundbar below your TV), and then fix the Wall Mount Guide to the wall using tape.

•• If you are not mounting below a TV, place the Center Line in the center of the installation area.

Center Line

3.Push a pen tip or sharpened pencil tip through the center of the A-TYPEimages on each end of the Guide to mark the holes for the supporting screws, and then remove the Wall Mount Guide.

4.Using an appropriately sized drill bit, drill a hole in the wall at each marking.

•• If the markings do not correspond to the positions of studs, make sure you insert appropriate anchors into the holes before you insert the support screws. If you use anchors, make sure the holes you drill are large enough for the anchors you use.

5.Push a screw (not supplied) through each Holder-Screw, and then screw each screw firmly into a support screw hole.

(Not supplied)

6.Install the 2 Bracket-Wall Mounts in the correct orientation on the bottom of the Soundbar using 2 Screws.

•• When assembling, make sure the hanger part of the Bracket-Wall Mounts are located behind the rear of the Soundbar.

Rear of Soundbar

Right end of Soundbar