Manually connecting the Subwoofer if automatic connection fails, ID SET

Manually connecting the Subwoofer if automatic connection fails

Before performing the manual connection procedure below:

•• Check whether the power cables for the Soundbar and subwoofer are connected properly.

•• Make sure that the Soundbar is turned on.

1.Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.

•• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.

5 Sec

Rear of Subwoofer

2.Press and hold the Up button on the remote control for at least 5 seconds.

•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.

•• The Soundbar will automatically power on when ID SET is complete.

SOUND

MODE

3.Check if the LINK LED is solid blue (connection complete).

The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer.

Blue is On

ENG - 18