2.Check the standby status of the Wireless Receiver Module after plugging it into an electrical outlet.
•• The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please refer to the
POWER
L | R |
SURROUND SPEAKERS OUT | |
SPEAKER IMPEDANCE : 3Ω | |
ID SET 
POWER
5 Sec
ID SET 
STANDBY
LINK
LINK
Blue blinking
3.Press and hold the Up button on the remote control for at least 5 seconds.
•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
•• The Soundbar will automatically power on when ID SET is complete.
PAIR
5 Sec
ID SET
SOUND
MODE
CAUTION•• If your Soundbar was playing music when it connects to the
4.Check if the LINK LED is solid blue (connection complete).
STANDBY
LINK
LINK
Blue is On
The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Receiver Module.
5.If
ENG - 9
