•• If “TV ARC” does not appear in the display window of the Soundbar main unit, confirm that the HDMI cable is connected to the correct port.
•• Use the volume buttons on the TV’s remote control to change the volume on the Soundbar.
Connecting using an Optical Cable
|
|
| Bottom of the Soundbar |
|
|
| AUX IN |
|
|
|
|
|
| DIGITAL AUDIO IN (OPTICAL) | |
|
|
OPTICAL OUT | Optical Cable |
|
D.IN | Right Side of the Soundbar |
|
1.Connect the DIGITAL AUDIO IN (OPTICAL) jack on the Soundbar to the OPTICAL OUT jack of the TV with a digital optical cable.
2.Press the
(Source) button on the right side panel or remote control, and then select the “D.IN” mode.
Auto Power Link
Auto Power Link automatically turns on the Soundbar when the TV is turned on.
1.Connect the Soundbar and a TV with a digital optical cable as described in Step 1 on the previous page.
2.Press the Left button on the remote control (the blue spot in the illustration to the right) for 5 seconds to turn Auto Power Link on or off.
•• Auto Power Link is set to ON by default.
(To turn off this function, hold the Left button on the remote for 5 seconds.)
•• Depending on the connected device, Auto Power Link may not function.
•• This function is only available in the “D.IN” mode.
ENG - 10
