CONNECTIONS, Link indicator, ID SET, ID SET

CONNECTIONS

Link indicator

1.Plug the power cords of the main unit and subwoofer into an AC wall outlet.

2.Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.

•The LINK indicator (Blue LEDs) blinks quickly.

3.While the main unit is powered off, press and hold the (Mute) on the remote control for 5 seconds.

4.The ID SET message appears on the Soundbar's display.

5.To finalize the link, turn the main unit’s power on while the subwoofer’s Blue LED blinks.

•The main unit and the subwoofer should now be linked (connected).

•The LINK indicator (Blue LED) on the subwoofer should be glowing continuously and not blinking.

•If the LINK indicator is not solid blue, the linking process has failed. Turn off the main unit and start again from Step 2.

•You can enjoy better sound from the wireless subwoofer by selecting a Sound Effect. (See page 9)

●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord. ●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar,

interference may cause some sound interruption.

●● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about 32.8 ft, but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless signal cannot penetrate metal.

●● If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the connection between the main unit and wireless subwoofer.

●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

●● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

18