Bracket-Wall, 2 Bracket-Wall pieces

2.Mark the location where the screws will go through on the wall, and then remove the Wall Mount Guide. Next, drill holes for the screws using an appropriately sized drill bit.

Center Line

Center Line

3.Fasten the 2 Bracket-Wallpieces firmly to the wall at the marked locations using the appropriate screws.

4.Attach the Soundbar to the 2 Bracket-Wallpieces as shown in the illustration.

5.Insert a Holder-Fix Mount into each hole on the product’s bottom side. Tighten each Holder-Fix Mount to fix the Soundbar to the

•• Do not hang onto the installed unit and avoid striking or dropping the unit.

•• Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may cause an injury or damage the product.

•• When the unit is installed on a wall, please make sure that children do not pull any of the connecting cables, as this may cause it to fall.

•• For the optimal performance of a wall mount installation, install the speaker system at least 2 inches (5 cm) below the TV, if the TV is mounted on the wall.

•• For your safety, if you do not mount the unit on the wall, install it on a secure, flat surface where it is unlikely to fall.