Before performing the manual connection procedure below:

Manually connecting the Subwoofer or Surround Speakers if automatic connection fails

Before performing the manual connection procedure below:

•• Check whether the power cords for the Soundbar and subwoofer or Surround Speakers are connected properly.

•• Make sure that the Soundbar is turned on.

1.Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds.

•• The red indicator at the rear of each speaker turns off and the blue indicator blinks.

Blue LED Blinking Fast

5 Sec

x 2

Rear of the Left and Right Surround Speakers

2.Press and hold the Up button on the remote control for at least 5 seconds.

•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.

•• The Soundbar will automatically power on when ID SET is complete.

SOUND

MODE

ENG - 7