If UPDATE is not displayed

6.When the update finishes, the Soundbar turns off. Press the pbutton on the remote control for 5 seconds. “INIT” appears on the display and then the Soundbar turns off. The update is complete.

•• This product has a DUAL BOOT function.

If the firmware fails to update, you can update the firmware again.

7.Reset your settings.

If UPDATE is not displayed

1.Turn off the Soundbar, disconnect and then reconnect the USB storage device that contains the update files to the Soundbar’s

USB port.

2.Disconnect the Soundbar’s power cord, reconnect it, and then turn on the Soundbar.

NOTES

•• The firmware update may not work properly if audio files supported by the Soundbar are stored in the USB storage device.

•• Do not disconnect the power or remove the USB device while updates are being applied. The main unit will turn off automatically after completing the firmware update.

•• After the update is completed, the user setup in the Soundbar is initialized so you can reset your settings. We recommend you write down your settings so that you can easily reset them after the update. Note that updating firmware resets the subwoofer connection too.

If the connection to the subwoofer is not re-established automatically after the update, refer to page 7.

If the software update fails, check if the USB stick is defective.

•• Mac OS users should use MS-DOS (FAT) as the USB format.

•• Updating via USB may not be available, depending on the USB storage device manufacturer.