4. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
LINK
Blue is On
The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Receiver Module.
5.If the
|
| LED status | Action |
|
|
|
|
| On | Connected with the Soundbar | - |
|
|
|
|
LINK (Blue) |
| Check if the Soundbar is turned on | |
| Blinking | Connection standby status |
|
| Repeat steps 3 through 4. | ||
|
|
| |
|
|
|
|
|
|
| Check if the Soundbar is turned on |
1. Press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue).
STANDBY | On | Connection failure |
|
|
(Red) |
|
| ||
| L | R |
| |
|
| 5 Sec | ||
|
|
|
| |
|
| SURROUND SPEAKERS OUT | ID SET | |
|
| SPEAKER IMPEDANCE : 3Ω | ||
|
|
| ||
|
|
| ID SET |
|
2. Repeat steps 3 through 4.
Others | - | Errors | Contact a Samsung Service Center. |
ENG - 10
