If the device fails to connect, Disconnecting the Soundbar from the TV

Samsung Standard

HW-N400 HW-N400/ZA

Download 74 pages 53.24 Kb View all pages
Page 15
Page screenshot 15
If the device fails to connect

If the device fails to connect

•• If the previously connected Soundbar listing (e.g. “[AV] Samsung Soundbar Nxxx N-Series”) appears in the list, delete it.

•• Press the What is the difference between BT READY and BT PAIRING? PAIR button on the remote control or in “BT” mode, press and hold the Disconnecting the Soundbar from the TV (Source) button for more than 5 seconds on the right side of the Soundbar to switch to “BT PAIRING” mode. Then, select “[AV] Samsung Soundbar Nxxx N-Series from the TV’s search list.

What is the difference between BT READY and BT PAIRING?

•• BT READY : In this mode, you can search for previously connected TVs or connect a previously connected mobile device to the Soundbar.

•• BT PAIRING : In this mode, you can connect a new device to the Soundbar. (Press the (Play/Pause) PAIR button on the remote control or press and hold the BT READY (Source) button for more than 5 seconds on the right side of the Soundbar while in “BT” mode.)

NOTES

•• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.

•• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the Soundbar and the Bluetooth device exceeds 32.8 ft.

•• The Soundbar automatically turns off after 5 minutes in the Ready state.

•• The Soundbar may not perform Bluetooth search or connection correctly under the following circumstances:

––If there is a strong electrical field around the Soundbar.

––If several Bluetooth devices are simultaneously paired with the Soundbar.

––If the Bluetooth device is turned off, not in place, or malfunctions.

•• Electronic devices may cause radio interference. Devices that generate electromagnetic waves must be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.

Disconnecting the Soundbar from the TV

Press the Manual background (Source) button on the right side panel or on the remote control and switch to any mode but “BT”.

•• Disconnecting takes time because the TV must receive a response from the Soundbar. (The time required may differ, depending on the TV model.)

•• To cancel the automatic Bluetooth connection between the Soundbar and TV, press the

p(Play/Pause) button on the remote control for 5 seconds in “BT READY” status. (Toggle On → Off)

ENG - 9

Page 15
Page screenshot 15
If the device fails to connect - Samsung Standard HW-N400/ZA