Press the
PAIR button. “BT PAIRING” appears in the Soundbar’s display.
PAIR | You can connect to a new Bluetooth device in this mode by selecting the device from the |
Bluetooth | Bluetooth device search list. |
| |
PAIR |
|
Press the pbutton to pause a music file temporarily.
When you press the button again, the music file plays. | |
•• | Auto Power Down Function |
Play / Pause | The unit turns off automatically in the following situations. |
––D.IN / HDMI / BT / USB Mode : If there is no audio signal for 5 minutes.
––AUX Mode :
––If the Audio (AUX) Cable is disconnected for 5 minutes.
––If there is no KEY input for 8 hours when the Audio (AUX) Cable is connected. (Auto Power Down function can be turned off only in that case.)
––To turn off Auto Power Down function, while in “AUX” mode, press and hold the pbutton for 5 seconds.
Up/Down/
Left/Right
Press the indicated areas to select Up/Down/Left/Right.
Press Up/Down/Left/Right on the button to select or set functions.
•• Repeat
To use the Repeat function in “USB” mode, press the Up button.
•• Music Skip
Press the Right button to select the next music file. Press the Left button to select the previous music file.
•• Anynet+ / Auto Power Link
You can turn Anynet+ and Auto Power Link on or off.
Anynet+ and Auto Power Link are controlled by the Right and Left buttons respectively.
––Anynet+ : If the Soundbar is connected to a Samsung TV through an HDMI cable, you can control your Soundbar with a Samsung TV remote control.
Press and hold the Right button for 5 seconds to toggle Anynet+ ON and OFF.
––Auto Power Link : If the Soundbar is connected to your TV through a digital optical cable, the Soundbar can automatically turn on when you turn on your TV. Press and hold the Left button for 5 seconds to toggle Auto Power Link ON and OFF.
––Anynet+ / Auto Power Link are set to ON by default.
ENG - 19
