CONNECTING THE SURROUND SPEAKERS

CONNECTIONS

●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

●● If the main unit is powered off, the wireless subwoofer will be in standby mode and the STANDBY LED on the upper side will come on after the Link indicator (Blue LED) blinks for 30 seconds.

●● If you use a device that uses the same frequency (2.4GHz/5.0GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption.

●● The maximum transmission distance of the wireless signal between the main unit and the subwoofer and the main unit and the SWA-7000S is about 32.8 ft, but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer or the main unit and the SWA-7000S, the system may not operate at all, because the wireless signal cannot penetrate metal.

●● If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the connection between the main unit, the wireless subwoofer, and the SWA-7000S.

●● The wireless receiving antenna is built into the wireless subwoofer and the SWA-7000S. Keep the both units away from water and moisture.

●● For optimal listening performance, make sure that the areas around the wireless subwoofer and SWA-7000S areas clear of any obstructions.

ENG

SURROUND SPEAKERS OUT

SPEAKER IMPEDANCE : 3Ω

ID SET

Surround Speaker (L)

Surround Speaker (R)

Wireless Receiver Module

●● Place these speakers to the side of your listening position. If there isn't enough room, place these speakers so they face each other. Position them about 2 to 3 feet above your ear, facing slightly downward.

●● Surround speakers must be connected to the wireless receiver module.

●● Each speaker has a colored label on its back or underside. Each cable has a single colored band near its end. Match the band on each cable to the speaker label by color, and then connect the cable to the speaker.