Connecting the Subwoofer, Automatic Connection, CONNECTIONS

CONNECTIONS

CONNECTIONS

Connecting the Subwoofer

●● Do not connect the power cord of this product or your TV to a wall outlet until all connections between components are complete.

●● Before moving or installing this product, be sure to turn off the power and disconnect the power cord.

●● If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear will be Red after blinking Blue several times.

●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption.

●● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about 32.8 ft, but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless signal cannot penetrate metal.

●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

●● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

Automatic Connection

1.Connect a power supply to the subwoofer.

2.Connect a power supply to the Soundbar, and then press the button on the remote control or on the right side of the Soundbar.

3.The subwoofer will be automatically connected to the Soundbar.

4.When auto pairing is complete, the blue indicators at the rear of the subwoofer turn on.

●● If the red indicator at the rear of the subwoofer is on or the blue indicator flashes continuously, auto pairing cannot occur. If this happens, connect the subwoofer manually, as shown on the next page.

●● You can enjoy better sound from the wireless subwoofer by selecting a Sound Effect. (See page 10.) ●● Important: Before you begin, put the batteries into the remote. See page 12 for instructions.

ENG

POWER

LINK