13 TROUBLESHOOTING
Refer to the table below if this product does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off the product, disconnect the power
cord, and contact Samsung Electronics at
;; Check whether the power cord of the Soundbar is correctly inserted into the outlet.
Soundbar works erratically.;; After removing the power cord, insert it again.
;; Power cycle the external device and try again.
;; If there is no signal, the Soundbar automatically turns off after a certain period of time. Turn on the power. (See page 8.)
If the remote control does not work.;; Point the remote directly at the Soundbar. ;; Replace the batteries with new ones.
Soundbar does not output any sound.;; The volume of the Soundbar is too low or muted. Adjust the volume.
;; When any external device (STB, Bluetooth device, mobile device, etc.) is connected, adjust the volume of the external device.
;; For sound output of the TV, select Soundbar. (Samsung TV: Home ( 
) → Menu → Settings ( 
) → All Settings ( 
)
→Sound → Sound Output → Select
Soundbar)
;; The cable connection to the Soundbar may not be loose. Remove the cable and connect again.
;; Remove the power cord completely, reconnect, and turn the power on.
;; Reset the product and try again. (See page 32.)
;; Check whether the LED indicator on the rear of the Subwoofer is on in blue. Reconnect the Soundbar and Subwoofer if the indicator is blinking slowly in blue or turned red. (See page 18.)
;; You may experience an issue if there is an obstacle between the Soundbar and Subwoofer. Move devices to an area away from obstacles.
;; Other devices sending radio frequency signals in proximity may interrupt the connection. Keep your speaker away from such devices.
;; Remove and reconnect the power plug.
The Subwoofer volume is too low.;; The original volume of the content you are playing may be low. Try adjusting the Subwoofer level. (See page 13.)
;; Bring the Subwoofer speaker closer to you.
Soundbar does not appear on the Bluetooth device list of the TV.;; Disconnect the power cord of the Soundbar completely and reconnect, and then try searching again. (See page 21.)
;; Connect the TV and Soundbar with an optical cable, and select the “D.IN” mode by pressing the 
(Source) button on the top of the Soundbar. See if the audio output works normally, and try searching again. (See page 21.)
ENG - 34
