Connecting an SWA-W500(Sold Separately) to your Soundbar

Connecting an SWA-W500 (Sold Separately) to your Soundbar

1.Turn off the Soundbar by pressing the (Power) button on the remote control.

Red Blinks X3

PAIR

2.Plug in the Wireless Subwoofer, and then check its standby status.

•• Plug the Wireless Subwoofer power cord into an electrical outlet and into the Wireless Subwoofer to turn on the Wireless Subwoofer. The LINK LED indicator (blue LED) on the Wireless Subwoofer blinks. If the LED does not blink, press the ID SET button on the rear of the Wireless Subwoofer with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please refer to the SWA-W500 user manual.

•• The main unit is heavy. Be careful not to pinch your fingers when pressing the ID SET button or connecting the power cord to the rear of the unit.

•• The upper part of the subwoofer is prone to scratches. Handle it carefully.

•• Do not press on or strike the Speaker Unit on the bottom of

Bottom of the Wireless Subwoofer

ENG - 19