3.Connect the Wireless Receiver Module to the two Surround Speakers.
•• The speaker cables are color coded.
L | R |
SURROUND SPEAKERS OUT | |
SPEAKER IMPEDANCE : 3Ω | |
| ID SET |
L | R |
SURROUND SPEAKERS OUT
POWER
4.Plug in the Wireless Receiver Module, and then check its standby status.
•• The LINK LED indicator (blue LED) on the Wireless Receiver Module should blink. If the LED does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please refer to the
POWER
L | R |
SURROUND SPEAKERS OUT | |
SPEAKER IMPEDANCE : 3Ω | |
ID SET 
POWER
5 Sec
ID SET 
STANDBY
LINK
LINK
Blue
blinking
5.Press and hold the Up button on the remote control or press the ID SET button on the bottom panel for at least 5 seconds.
•• The ID SET message appears on the display of the Soundbar for a moment, and then disappears.
•• The Soundbar will automatically power on when ID SET is complete.
ID SET
PAIR
5 Sec
OUND
ENG - 24
