![ID SET](/images/backgrounds/7959/795955x1.webp)
4.Press and hold the Up button on the remote control or press the ID SET button on the bottom panel for at least 5 seconds.
•• The ID SET message appears on the display of the Soundbar for a moment, and then disappears.
•• The Soundbar will automatically power on when ID SET is complete.
ID SET
PAIR
5 Sec
OUND
5. Check if the LINK LED is solid blue (connection complete).
Stops blinking.
Glows blue.
Front of the Wireless SubwooferNOTESThe LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer.
––Do not connect the power cord of this product or your TV to a wall outlet until all connections between components are complete.
––Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
––The maximum transmission distance of the wireless signal of the main unit is about 32.8 ft, but may vary depending on your operating environment. If a
––Wireless receiving antennas are built into the wireless subwoofer. Keep the units away from water and moisture.
––For optimal listening performance, make sure that the area around the wireless subwoofer and Wireless Receiver Module (Sold separately) is clear of any obstructions.
ENG - 28