![Connecting the Wireless Surround Speaker](/images/backgrounds/7997/799723x1.webp)
Connecting the Wireless Surround Speaker
1. Connect the Wireless Receiver Module to 2 Surround Speakers
Use the speaker cables to connect the two surround sound speakers to the Wireless Receiver Module.
•• The speaker cables are color coded.
L | R |
| ID SET |
L | R |
SURROUND SPEAKERS OUT | |
| POWER |
When connecting the speaker cables to the Wireless Receiver Module, follow these steps:
1.Insert the grey plug into the grey jack on the Wireless Receiver.
2.Insert the blue plug into the blue jack on the Wireless Receiver.
When connecting the speaker cables to the surround speakers, follow these steps:
1.Match the speaker cable connected to the grey jack to the speaker with the grey label.
2.Match the speaker cable connected to the blue jack to the speaker with the blue label.
3.Insert the red and black colored ends of each speaker cable into the red and black jacks of the
appropriate speaker.
•• The labels are on the backs of the speakers.
2. Check the standby status after plugging into an electrical outlet
Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, refer to step 8 on page 9.
POWER
L | R |
|
|
| STANDBY |
SURROUND SPEAKERS OUT | LINK | |
SPEAKER IMPEDANCE : 3Ω |
ID SET
LINK
Blue blinking
POWER
ENG - 6