Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
POWER
IN
Bottom of the Soundbar
Attach the Toroidal ferrite core to the power cord of the Soundbar to help prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make two loops in the Soundbar’s power cord.
3.Attach the Toroidal ferrite core to the Soundbar’s power cord as shown in the figure on the left, and then close it by pressing it until it clicks.
•• Ensure that the ferrite core is attached as close as possible to the power plug of the Soundbar.
3. Connect the main unit of the Soundbar to the Wirless Dongle
Connect the wireless dongle to the “WIRELESS” port on the Soundbar main unit.
•• When inserting the Wireless Dongle into the holder, make sure that the “WIRELESS” logo is facing up, as shown in the pictures below.
WIRELESS
WIRELESS 
2
Stand Type
2
D
WIRELESS 
WIRELESS
Wall Mount Type
| IN | |
1 | DIGITALAUDIO | |
(OPTICAL) | ||
| ||
| WIRELESS | |
| AUXIN |
| IN |
1 | DIGITALAUDIO |
| (OPTICAL) |
| WIRELESS |
| AUXIN |
WIRELESS
WIRELESS
WIRELESS 
One Mount Type (WMN300SB, not supplied)
ENG - 7
