CONNECTIONS
Connecting to a TV
●● Important: Before you begin, put the battery into the remote. See page 11 for instructions.
Connecting to a TV Using a Digital Optical Cable
Optical Cable
OPTICAL OUT | DIGITAL AUDIO IN |
| (OPTICAL) |
DIGITAL AUDIO IN (OPTICAL)
1.Connect the DIGITAL AUDIO IN (OPTICAL) jack on the Soundbar to the OPTICAL OUT jack of the TV with a digital optical cable.
| 2. Press the | button on the right side of the Soundbar or the SOURCE button on the remote control to select |
the D.IN mode. |
|
++Auto Power Link
If you have connected the main unit to a TV with a digital optical cable, you can set the Auto Power function ON to have the Soundbar turn on automatically when you turn the TV on.
1.Connect the Soundbar and a TV with a digital optical cable.| 2. Press the | button on the main unit’s right side or the SOURCE button on the remote control to select the |
D.IN mode. |
|
3.Press the button on the remote control for 5 seconds to turn Auto Power Link on or off.
●● Auto Power Link is set to ON by default.●● Depending on the connected device, Auto Power Link may not function.ENG
21
