Manually connecting the Subwoofer or Surround Speakers if automatic connection fails
Before performing the manual connection procedure below:
•• Check whether the power cables for the Soundbar and subwoofer or Surround Speakers are connected properly.
•• Make sure that the Soundbar is turned on.
1.Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds.
•• The red indicator at the rear of each speaker turns off and the blue indicator blinks.
5 Sec
Rear of Subwoofer
Blue LED Blinking Fast
Blue LED Blinking Fast
5 Sec
x 2
Rear of the Left and Right Surround Speakers
2.Press and hold the Up button on the remote control for at least 5 seconds.
•• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
•• The Soundbar will automatically power on when ID SET is complete.
5 Sec |
|
PAIR |
|
| “Samsung Harman Kardon” logo is on the top |
ID SET
SOUND
MODE
ENG - 7
