•• If “TV ARC” does not appear in the display window of the Soundbar main unit, confirm that the HDMI cable is connected to the correct port.
•• Use the volume buttons on the TV’s remote control to change the volume on the Soundbar.
NOTES
•• HDMI is an interface that enables the digital transmission of video and audio data with just a single connector.
•• If the TV provides an ARC port, connect the HDMI cable to the HDMI IN (ARC) port.
•• We recommend you use a coreless HDMI cable if possible. If you use a cored HDMI cable, use one whose diameter is less than 0.55 inches.
•• Anynet+ must be turned on.
•• This function is not available if the HDMI cable does not support ARC.
Connecting using an Optical Cable
Bottom of the Soundbar
Optical Cable (not supplied)
DIGITAL AUDIO IN (OPTICAL)
OPTICAL OUT
Top of the Soundbar
D.IN
1.Connect the DIGITAL AUDIO IN (OPTICAL) jack on the Soundbar to the OPTICAL OUT jack of the TV with a digital optical cable (not supplied).
2.Press the
(Source) button on the top panel or on the remote control, and then select the “D.IN” mode.
Auto Power Link
Auto Power Link automatically turns on the Soundbar when the TV is turned on.
1.Connect the Soundbar and a TV with a digital optical cable (not supplied).
2.Press the Left button on the remote control for 5 seconds to turn Auto Power Link on or off.
•• Auto Power Link is set to ON by default.
(To turn off this function, press the Left button on the remote for 5 seconds.)
•• Depending on the connected device, Auto Power Link may not function.
•• This function is only available in the “D.IN” mode. ENG - 10
