Getting started
Tools
The Tools panel provides handy instruments for quick access.
1.From any screen, drag the Edge handle to the center of the screen. Swipe until the Tools panel is displayed.
2.Tap a tool to use:
•Compass: Identify compass directions.
–Tap Calibrate to calibrate the compass.
•Tally counter: Use the plus and minus icons to add or subtract while counting.
–Tap Vibration to enable or disable vibrations with each addition or subtraction.
–Tap Target to set a total target number between 1 and 9999.
–Tap
0
Reset to reset the counter.
•Flashlight: Tap 
Flashlight to turn the flashlight on and off. Use the plus and minus icons to increase or decrease the brightness of the light.
–Tap SOS to make the flashlight signal the phrase “SOS” in Morse code.
•Surface level: Use the device to determine if a surface is level by placing the device on the surface. The surface is level when the x and y values are close to or equal to zero degrees.
–Tap Calibrate to calibrate the level.
•Ruler: Use the edge of the device as a ruler to measure a straight line in either inches or centimeters. Tap the unit name to change the units.
–Tap Calibrate to calibrate the ruler.
37
