advanced recording
Using the touch point function
Using the Touch Point function, you can have the camcorder focus on a small section of the picture. You get the camcorder to focus on a particular point by touching the desired point on the LCD screen.
To activate the touch point with a long touch
You can activate touch point by lightly pressing a particular point on the LCD screen for about 2 seconds.
STBY 00:00:00 | [307Min] |
9999 
• The Auto Focus (AF) setting is useful when you operate the zoom function because you might not be able to keep accurate focus after the zoom ratio has been changed.
•In the manual focus setting menu screen, you can access auto focus by touching the AF ( 
) tab on the screen. You can return to manual focus by touching the manual focusing tabs.
•If you have enabled the Touch Point function, you can reset the focus to Auto by touching the AF
( 
) tab on the LCD screen.
Anti-Shake (OIS: Optical Image Stabiliser)
Smart OIS improves on existing Optical Image Stabilisation by allowing the camcorder lens to shift over wider range of motion in wide/tele zoom position. This allows the camcorder to compensate for greater degrees of camcorder shake and delivers a stunning level of image smoothness.
PRECHECK!
Select the record mode by pressing the MODE button. ¬page 24
1.Touch the Menu ( 
) tab
2.Touch the desired submenu item.
3.To exit the menu, touch the Exit ( 
) or Return ( 
) tab.
Submenu items
•Off:Disables the function.
•On ( 
)The
Use the
•When recording while walking or riding in a moving car.
•When recording with the zoom function.
•When recording subjects of a small size.
Off
On
1/1
58
