Displaying the Date/Time (Date/Time)

ENGLISH

臺灣

Initial Setting: Display Menu Setting 起始設定：顯示選單設定

The Date/Time function works in Camera Mode/Player Mode/ M.Cam Mode/M.Player Mode. page 26

The date and time are automatically recorded on a special data area of the disc.

顯示日期/時間（Date/Time）

 Date/Time 功能可在 Camera Mode/Player Mode/M.Cam Mode/ M.Player Mode 下操作。 第 26 頁

 日期和時間會自動記錄在光碟的特殊資料區域。

1.Set the [Mode] switch to [DISC] or [CARD].

2. Set the [Power] switch to [		(Camera)] or
[	(Player)].

3.	Press the [MENU] button.
	 The menu list will appear.
4.	Move the [Joystick] up or down to select
	<Display>, then press the [Joystick(OK)].

Move OK Select MENU Exit

1.設定 [Mode] 開關為 [DISC] 或 [CARD]。

2. 設定 [Power] 開關為 [	(Camera)] 或
[ (Player)]。

3.按下 [MENU] 按鈕。

 選單清單將會顯示。

4.向上或向下移動 [Joystick] 以選擇

<Display>，然後按 [Joystick(OK)]。

5.	Move the [Joystick] up or down to select
	<Date/Time>, then press the [Joystick(OK)].
6.	Move the [Joystick] up or down to select the
	display type of the Date/Time, then press the
	[Joystick(OK)].
	 Display type of the Date/Time: <Off>,
	<Date>, <Time>, <Date&Time>.

Move OK Select MENU Exit


7.	To exit, press the [MENU] button.

Notes		附註
	The Date/Time will read 12:00 AM JAN.01.2006 in the following	 在下列情況下，日期/時間將顯示為 12:00 AM JAN.01.2006。
	conditions.	- 播放光碟的空白部份。
	- During playback of a blank section of a disc.	- 若光碟是在設定 DVD 攝錄放影機的 Date/Time 前錄製。
	- If the disc was recorded before setting the Date/Time in the	- 鋰電池電量不足或耗盡。
	DVD Camcorder.	 使用 Date/Time 功能之前，您必須設定時鐘。第 30 頁
	- When the Lithium Battery becomes weak or dead.
	Before you use the Date/Time function, you must set the clock.
	page 30