Maintaining Water and Dust, Resistance

Caution: If the SIM card or the memory card is not

inserted correctly, the device cannot detect it. Reorient

device components or an internally sealed system,

the SIM card or memory card and place it back into the

slot if it is not detected.

Follow these tips carefully to prevent damage to the

Maintaining Water and Dust

device.

• Any device which uses accessible compartments or

Resistance

This device is rated IP68 using the Ingress Protection

ports that can be opened should have these sealed

or closed tightly to prevent liquid from entering

rating system.

Your device has been tested in a controlled

• Whenever your device gets wet, dry it thoroughly

environment and shown to be water and dust resistant

with a clean, soft cloth.

in certain circumstances (meets requirements of

• Do not expose the device to salt water or ionized

classification IP68 as described by the international

standard IEC 60529 - Degrees of Protection provided

water, or to water over 5.0 feet deep for more than

30 minutes. If your device is exposed to fresh water,

by Enclosures [IP Code]; test conditions: 15-35°C,

dry it thoroughly with a clean, soft cloth. If the

86-106 kPa, 5.0 feet, for 30 minutes). Despite this

device is exposed to any liquid other than fresh

classification, your device is not impervious to water

water, rinse the device with fresh water immediately

damage in any situation. It is important that all

and dry it thoroughly with a clean, soft cloth.

compartments are closed tightly.

Failure to rinse the device in fresh water and dry it

as instructed may cause the device to suffer from

operability or cosmetic issues.

Getting Started

6

Assemble Your Device